2013 caravan not starting

Question

programming appears to have worked. blue led flashed with each press of oem fob lock. car does not start. purchased a packaged/pre programmed unit with t harnass. slick install. but no start currently. ground is good at black wire. power is good at yellow/blue wire. no signal apparent on yellow/red. no other LEDs flash or turn on.

Answer 1

Your module is not set for 3x lock. You need the Flashlink Updater to change the option.

Need to enable option D1.10

Comments

Bummer. E&B Electronics on Amazon was selling this with the understanding that it was fully programmed.... " Preloaded / Prewired ready to install module & T-Harness combo for your vehicle." "Latest firmware guaranteed" "Remote start your vehicle off your existing factory remote by hitting lock 3x!" https://www.amazon.com/dp/B00NBCF4VY/ref=cm_sw_r_other_apa_i_yeVdCbTEYPW6G. I'll get with them to see if it can be rectified without my having to purchase the link

---

Have you resolved this yet?  I have the exact same issue with the same van.