2013 Dodge Caravan connected and programmed but not starting vehicle.

Question

2013 Dodge Grand Caravan

Service # 001A06781796 Evo-CHRTx pre-loaded

Firmware 74-22

The yellow wire from the T harness has been connected to the yellow wire of the 20 pin connector.

Installation programming went fine and the device seems responsive but using the lock button 3 times does not start the vehicle.

Each time the remote lock button is pushed the module flashes blue once.

Answer 1

Any other light flash after the 3 blue flash ?

Comments

We grounded the dark blue wire and that resulted in the red light being on constantly. And a clicking noise in the box. This should confirm remote start is on. When the dark blue wire is not grounded it goes through programming just fine and only the blue flashes once when the unlock button is hit.