No key detected after decryptor

Question

2013 mks PTS evoall hardwired to viper4806

Evoall programmed successfully and decryptor used  when remote starting red light and then yellow red come on evoall

Brake lights come on and interior lights come on  then message of No Key Detected and alarm goes off

SN  001A07 150161

71.52 loaded

Answer 1

Hello,

I would take a look at your Tx connection, if it is on the wrong side of the cut the module will program from a-z but not remote start since the data is going to the wrong location in the vehicle.

Best regards

Comments

Pulled out ohmmeter to check connections and they are correct

checked can bus wiring and push to start wire and correct

OEM remote starter working fine.

tried activating 3x lock as standalone and it doesn't do anything (I don't think remote start sequence started)

does running decryptor again increase key count in car?

---

No it does not.

I would suggest then at this point to phone into the support line so an agent can go over it with you. Be sure to have the module, flasher and vehicle on hand when calling in.

1-877-336-7797

Mon - Fri

8am 6pm est

Best regards