installing Evo-All in 2008 Nissan Altima PTS Hybrid module not finishing programming

Question

using installation guide #84521. get to last step in programming(# 8 flashing yellow) which I get once I turn off ignition (by pressing the PTS button once) i get a Red & Yellow alternating flash. which would mean Decryptor is ready right? steps do not mention decryptor at all. And I dont get the decryptor option in the Flashlink Software. Have confirmed Hybrid mode is on and even attempting rolling FW back for minimum required as listed in guide

Answer 1

There is no dcryptor to do on that vehicle. If the red and yellow are alternating, that means the module you are using was previously used on another vehicle that did require the dcryptor.

 

Reset the module then redo the programming. Note that reseting the module will also clear the module options back to default.

1. Hold down programming button while plugging in datalink connector.
2. Let go of button when LED is RED.
3. Push and hold button again until all three LEDs start to alternate.
4. Disconnect unit