2012 nissan murano wont start after evo all install

Question

hello i have a 2012 nissan murano i just installed the evo all with the nist1 harness. for the oem 3x lock. the wiring and programing was shaky at first but i started over and got it right the second time. I can see that the module is responding to the oem remote (blue light flashes when lock button is hit) but the car never starts. one thing that i noticed is that the red light never come on after the 3x lock nor do the brake lights.

Answer 1

Typically some options need to be enabled at the time of installation for the unit to function off the OEM remotes. Refer to page 2.

 

If you purchased this unit through an online reseller, it may already be setup for you although i do not currently see that option ON. A quick little test for you, would be to grab the DARK BLUE wire from the 20-pin connector and simply ground it. If the RED LED turns on, then the unit is currently NOT setup for OEM start.

Comments

robert,

thank you for your quick response, yes when i ground out the dark blue wire the red light comes on. So does that mean i need to get the flash updater 2 that i keep reading about? then enable the oem start