Why is my light staying blue when i install the input wire for input B on EVO-ALL (AUDI)

Question

This is probably my 5th evo install. My first time for an older car.. I have a 2008 Audi A4. I purchased the Evo All for the remote starter install. I used install guide 85651... first thing i did was the software download. In the software download only thing I edited was i turned on Standalone function, which was off. Once i did the original download.... next was the wiring. I did everything that was in the guide for without data link: san data link... so, once I plugged the plug in plug B. then the rest of the plugs. It just turned Blue. There was no Blue, Red, Yellow and Blue & Red LEDs will alternatively illuminate. But with the blue light lit... I hit the remote.. it did everything like it was going to start the vehicle. Locked the door. Then I heard clicking coming from module like it was going to start but it didn't.. any suggestions. Your help will be appreciated.

Answer 1

Hello,

What is the S/N number on the back of the module?

What brand remote starter are you using with the evo-all?

Thank you.

Comments

SN:001A07 666717. I'm not using a remote starter... I thought the evo All, I can use as a standalone to use with my Oem remote...

---

Depending on the vehicle yes. On a 2008 Audi A4 standard key, No.

You would need an evo-one along with an rf kit. Remote start from oem remote is not supported on this vehicle.

Also please note key sacrifice is required for remote start to function.

https://fortin.ca/en/vehicles/audi/a4/2008-standard-key/compatibility/

---

Ok, that would explain it. I'll go to the site to purchase a rf kit.. thank you...

---

For that vehicle you would need the following parts for remote start:

1- evo-one-942 or evo-one-442 or evo-one-441

2- flash link updater (if you already have one you do not need a 2nd)

3- 1x vehicle key

Best regards