Questions & Answers

2008 Honda CRV, blue light flashing slowly after programming

0 votes
Following guide #57701 I have installed an EVO-ONE service no:002b07 184652 into a 2008 Honda CRV.

Programming steps 1-5 appear to go fine, at step 6 when i turn off the ignition the blue light starts flashing slowly and does not turn off.

I've verified wire connections and unplugged the module and attempted to start. The security light flashes and will not start.

Any idea what I have done wrong?
asked Oct 23, 2018 in Honda by c hansen (310 points)

2 Answers

+2 votes
- perform a master reset (http://www.wirecolor.com/en/qa/50193/faq-how-do-i-reset-my-evo-all?show=50193#q50193)

- then re enable any vehicle specific options

- then re program in vehicle.
answered Oct 23, 2018 by derek g (347,180 points)
worked perfectly.  Im glad that it was so simple.
commented Oct 23, 2018 by c hansen (310 points)
–1 vote
The module hasn't been flashed. You could configure first the options and update the firmware to the recommended version according to the guide and try again the programming.

bypass side 73.19

remote starter side: 1.24
answered Oct 23, 2018 by Antoine Marion (1,610 points)
I flashed the module. The status says I am on flash limit 3/8. 73.19 is not ana available firmware number to load into the module. I flashed both sides to the latest available firmware then I downgraded the bypass to 73.29. the remote start side is at 1.24
commented Oct 23, 2018 by c hansen (310 points)

Related questions

...