toyota avalon 2019

Question

I have a problem with the module. After updating the firmware, the device stopped working on the car. Please advise me of the solution and what is the appropriate firmware for the type of this car. Note that the car is Toyota Avalon 2019 Gasoline push-to-start 

the module SN:001A07286792 Evo-all

Answer 1

Hello,

- Fw 79.69 will work fine.

- Id suggest you do a master reset first: https://fortin.ca/en/download/61931/61931.pdf

- Re enabled the vehicle specific options.

- Once that is done re program the evo in the car including re runing dcryptor.

- Test system.

 

Best regards.

Comments

I did as you taught me. I did a reset and connected the unit to the vehicle and identified it on the key as directed. After the blue flash, the unit was connected to the computer, the options were saved and the decryptor was activated, but after finishing and connecting the unit to the vehicle, the unit cannot recognize the vehicle and the vehicle does not start.

---

Hello,

When you press lock on the OEM remote does the blue led on the evo blink?

When the vehicle is started normally, what led is lit up on the evo-all?

Also please turn off option A11 and re test.

Best regards.

---

Hello,

When you press lock on the OEM remote does the blue led on the evo blink? No, there is no leds from the device in any color

When the vehicle is started normally, what led is lit up on the evo-all? Yellow led

Best regards.

---

Your dcryptor is not loaded correctly. Please reset the module and start over with the programming. You will have to renable your units options aswell after doing the reset.

 

Info on resetting the module found here: https://fortin.ca/en/qa/50193/FAQ:-How-do-I-reset-my-EVO-ALL/?/

---

Thank you very much.

The device is working now, but one last question. Previously, the device has an option. If I close the door and the car is running, I can lock the doors. Now this feature does not work.

 What do I do to activate the feature?