Mycar not working properly with evo

Question

Mycar Lt2 won't work properly on evo one I believe it's paired as I can send commands,shows gps,battery. So problem is if I ready car then later send start signal it will start run a few seconds then shut down and unready vehicle also when I send lock/unlock it sends it three times on either senario as well as it always shows green unlock doors in the middle no matter what state car is in volt and gps seem to work okay I'm trying to get this module up and running please

Answer 1

Hello,

 

Sounds like the 2 units are not communicating properly possibly due to not being paired correctly.

Commands sent  in 3's (such as your locks) are a symptom of the modules not being able to confirm if the command has been executed succesfully. So it sends it 2 more times in hopes that one fo them will get through.

I would verify the app is set into the correct protocol then go through the in vehicle programming again: https://fortin.ca/download/64631/ascl6-install-guide-64631.pdf

 

Best regards.