All three LEDs blink after releasing programing button

Question

2017 vw golf alltrack, build date 10/16. Using guide 82231.  After 3 attempts evo-all appeared to take program. Hazard lights flashed, brake lights came on, car would not start.  Removed evo-all and rlink, disconnected vehicle battery to clear any vehicle issues. Reconnected battery installed Rlink.  At step 5 turning on key, no blue led lite on evo-all.  After connecting data line and releasing programing button all 3 leds flash for 1 minute . Turn on key no blue led. Suggestions?

Answer 1

what's the module 12 digit service number (s/n)?

 

Note: the rlink does not stay in the install, it's only there to program the module. Once programmed, replace the rlink with the TB-VW.

Comments

module sn 001A07 047147

build 06/19

had replaced rlink with tb-vw after I thought it had programmed.

rlink was in place when blue led would not light when turning ignition on.

---

Ok, you need to reflash your module and reset it since you already did 1 successful dcrpyor programming. The firmware on the initials flash and what is loaded into the unit after the dcryptor are two completely different things. 

 

reset procedure is here: https://fortin.ca/en/qa/50193/faq-how-do-i-reset-my-evo-all?show=50193#q50193

 

Note... you already did a successful dcryptor programming. If it was not working afterwards, the issue was elsewhere. Please call support if problem persists.