2018 Tundra does not lock doors after remote start.

Question

2018 Tundra Evo One installed and programmed, remote starts works with 3x lock button pressings , doors unlocks before it cranks but it does not lock back up after vehicle starts even thou option D5 is set..

firmware 79.45

options C1 D2 D5 setting protection Y

Evo One remote start firmware version 1.2.4

options 2.4, 38.2

thanks in advance for the help.

Dan

Answer 1

Turn off D2, it is not needed since a disarm wire is connected.

 

Double check the doorlock data connection. This is where the locks are controlled.

Comments

Hi Robb

 

thanks for your reply, before turnind D2 off truck will beep 3 times then 2 times (door unlock) then will crank and driver door would stay open.

 

I checked the wire doorlock and is tightly connected. I turned off D2 and truck will beep 3 times, driver door will still unlock then truck would crank and driver door would still stay open.

 

Turned A1 to off and now truck beeps 3 times door stays locked then truck would crank..it seems like thats the only way to keep drivers door close, is that the correct way or do you think turning off A1 would cause some other issues?

Dan

---

Hello, I am having this same issue on my 2018. Has this been solved? Robb please confirm A1 is the solution with no issues.

---

Charles A, What is the service number to the module?

Did you follow this guide for the installation?

Evo-One: http://cdn.fortin.ca/download/69701/evo-one_ig_reg_bi_toy-tundra_2018_hkey_a_69701.pdf

---

Derek, Yes I followed those instructions and installation went well. 

Service # 002B07 239605

 

Thanks

---

So your vehicle does not re lock after it remote starts, what does the blue led on the module do once it is remote started?

---

Once remote started, lights red and yellow are lit and stay lit. Blue is not on at all.

 

 

---

So your vehicle does not re lock after it remote starts?

---

That is correct. It will not lock. I can hit the lock button and it will lock and unlock again. It stays unlocked.

Thanks

---

Is the vehicle equipped with a factory alarm? If yes what wire was used to hook up to the dis arm wire in the vehicle?

---

I do not have the factory glass break sensor. 

Orange A6 was connected to Pin #2 in the harness. 

Should I try removing this wire (Orange A6)?

 

---

Yes try it and let me know.

---

Removed Orange A6 and the truck does not unlock anymore when starting. 

My alarm did go off with one of 3 starts

I will run with it for a few days and report back.

 

Thanks

 

---

Your alarm will always go off without that wire connected.

If you meter the orange wire does it always rest at ground?

---

They way I finally fixed mine was just turning on option 6.3 on the Evo-One Options, it's been working as suppossed after doing that.

---

Update, changed 6.3 to 6.1 and reflashed unit to latest software 79.49 and now truck locks after start, thanks.