Question

Vehicle unlocks when remote starts then won't relock. Does't lock or unlock using FOB but park lights blinks when lock or unlock button is pressed. Does it require to reprogram the EVO ALL?

Answer 1

What is the service number?

Also year, make and model?

Comments

2004 Chrysler Sebring 4 door sedan. I don't have here the vehicle right now so I don't have a service number. Just diagnosing for someone. I'm only assuming it was working fine before from the previous owner.

---

Is it set to unlock before lock after start?

If it is, is it the remote starter set to do it or the EVO?

Hard to troubleshoot without that service number...

---

Finally received text:  EVO Service number  001A06246827

I can see with this service number that it was programmed to 2003 ( car is 3/2003 ). I think should be early 2004 model.

I'm not familiar using this Fortin. DBALL much easier :)

---

Looking at that service the unlock before start/Lock after option is not selected in that module so...must be the remote start that is doing the action.

 

This can be seen here http://fortin.ca/en/support/001A06246827/

---

Could it be wired directly from remote start to vehicles door lock instead of from EVO  to door lock wire? If it is wired from EVO to door lock wire, I quess I have to turn on the D2 option?

---

I do not know if it is wired? You would have to look at the installation to find out.

You could get the evo to do it...If that was done you have to turn it off in the remote starter.

---

Yes you can directly wire the door locks from the remote starter to the lock wires in the vehicle. would suggest testing them first.

---

.

Yes, I have to see the installation. Probably in the week end since it's out of town.

Thanks for your help !

---

No problem!