Chrysler T&C Can't Shift To Gear???

Question

I installed the EVO ALL ON 2010  CHRYSLER TOWN & COUNTRY WITH T-HARNESS THAR-CHR4. EVERYTHING RUN GOOD, THE ONLY PROBLEM THAT I HAVE IS , I HAVE TO TURN OFF THE REMOTE START AND RESTART MY CAR AGAIN WITH KEY SO I CAN SHIFT IT TO GEAR. BECAUSE CAR CAN'T SHIFT TO GEAR IF I JUST GET IN AND TURN ON THE KEY.

IN THE INSTALLATION GUIDE SHOW THAT WE NEED TO CUT THE IGNITION WIRE AND CONNECT YELLOW /GREEN TO YELLOW OF THE MALE END OF THE T-HARNESS. IF CAR 2010 OR LESS, IF I CUT THE IGNITION, THE CAR WON'T START WITH KEY OR REMOTE AT ALL., SO I NEED TO RECONNECT THE IGNITION BACK IN.

MY QUESTION IS IF, I RECONNECT THE IGNITION BACK DO I NEED TO DISCONECT THE YELOW/GEEEN WIRE FROM THE EVO ALL AT THE RED PLUG.

Answer 1

This issue came up on 2010 and less Dodge Caravans mostly. The most recent guide has the modification required. Here is what you need to do:

1. Cut the  ignition wire as indicated
2. Connect the yellow/green wire of the EVOs red connector to the connector side of the cut.
3. Make sure that the yellow/red is vehicle side.

If a T-Harness (EVO-ALL Only) is being used, only do steps 1 and 2.

---

If the vehicle did not start when you made this modification then it was not done correctly.

Comments

I did the modification as you told me to. The vehicle did start and run with the Remote start, but when  I try to put the key in the and turn on, the engine will shut off after  I step on a Brake. And car not crank with the key.