2012 RAM 2500 gas wont flash blue to program

Question

I recieved the EVO-ALL CHRT4  remote start unit that was supposed to be already programmed by the vendor. After splicing the yellow wires together and installing the unit. I cannot get the unit to flash blue when the key is in. My firmware version on the unit is 74-19 but my invoice from the seller says 74-22 which is the most recent im guessing. Do i need to reprogram or change something in the setup on this unit?

Answer 1

Are you installting this as a stand alone?

what does the blue led do when you turn the ignition on? does it go out and stay out? does it stay on?

I checked your service number here http://fortin.ca/en/support/001A06570890/

It isnt showing any options turned on at the momemt for stand alone (if thats how you're installing it). Unless he turned them on in the offline menu.

Comments

ya the 2 pin does not apply to your situation. The firmware looks good from what i can see. As previously mentioned though i dont see any stand alone options turned on, unless it was done in the offline menu.

Not a problem glad to help...

---

Should there be stand alone options turned on?

---

Actually i looked a little closer and he flashed this as a Dodge Ram 2012. Not a Ram 2500 2012...check your connections first and go from their...yes options c1 (oem remote monitoring) and d1 (stand alone) should be on...youll find out once its programmed if he actually set them up...

---

I figured it out. I had a bent barbed pin on the main T harness. I remove the pin and spliced it to where it should connect. It programmed and everything is working correctly. Thanks for your help on this.

---

awsome! glad you figured this out:)