INT-SL+ will not program to my 2000 silverado

Question

i did all the instalation of my remote start and bypass but i can not get the bypass to program. i get as far as pressing the lock button to let the bypass and rcs comunicate, the led turns off, i put the in ignition and it never blinks to finish programming.  

Hardware Vr 2

firmare Vr 3.01

service no 002102050986

Answer 1

Hi Donald. I would verify your ignition connection. (pink wire from intsl+) test it to ensure proper voltage at key on and during crank to ensure it is truly a ignition. test it at the connector for the bypass.

Answer 2

Please flash firmware to 3.06 using the Flashlink Updater-2 (sold separately) after checking the yellow wire as Derek mentioned above and try to reprogram.

 

Thank you,