Questions & Answers

Lexus NX200t E400 + EvoAll Bypass can't copy key

+1 vote
I recently install E400 plus evoall bypass

After installing and rechecking the wiring twice, I can't seem to program the EvoAll to copy the Key

After getting the blue light on the EvoAll I plug all wire and the press 2x the star button nothing happen the EvoAll doesn't blink fast actualy no light at all.

I check the swap the diode and still nothing
asked Feb 27, 2015 in Lexus by Thuy Du Dao (650 points)

1 Answer

+1 vote
 
Best answer
Does the blue light goes off with ignition ?

Verify your can high and can low connection, and make sure you have the latest software.

Can you provide your module service number ?
answered Mar 1, 2015 by Thuy Du Dao (85,210 points)
selected Mar 3, 2015 by Robert T
Yes the blue light does go off with I turn ignition to on

And yes it is already on the lastest update

E400

Service No : 002c02 029687

EvoAll

service no : 001A06 354957

connection is good

can low around 2.3v - 2.7v

can high no voltage
commented Mar 1, 2015 by Thuy Du Dao (650 points)
edited Mar 2, 2015 by Thuy Du Dao
Your EVO-ALL has no firmware in it at the moment. Make sure to not disconnect the EVO form the flash-link until it has finalized the update.

http://fortin.ca/en/support/001a06354957/
commented Mar 2, 2015 by Robert T (301,890 points)
I found the problem wire on the diagram was mismatch can high and low.

Evo-All bypass defect even after update was successful didn't work had to go get other one.
commented Mar 3, 2015 by Thuy Du Dao (650 points)
You're very right. I corrected wirecolor info and sent a request to have the guides fixed.
commented Mar 3, 2015 by Robert T (301,890 points)

Related questions

...