WIRING CONNECTION EVO-ONE (REV.: 20141104 Guide # 23461)

Question

God day!

I am from Russia and write the electronic translator.

My question,

Wiring connection EVO-ONE Rev.:20141104 Guide # 23461  :  pin A5 White (-) Start OUT > manual transmission 1x180 Ohm Resistor > (-) Clutch pin 2 (3-pin Black cjnntrntor)  - this wiring connection is not work.

Unit EVO-ONE

Hardware 2

Firmware 70.15

Answer 1

Can you put a 180ohm resistor to directly to ground on the pin 2 and then start the car with the key without pushing on the clutch? Make sure you are in neutral when doing this test.

Comments

Thanks. Tomorrow I will try. We already night.

---

Thanks.Tomorrow I will try. In the city of Krasnodar night now.

---

Let us know your results. No rush.

---

I"am put 180ohm resistor directly to the ground at terminal 2 - the vehicle starts up from the key without pushing on the clutch!

The second question.

This tehnical error (constructive), the bugr in the fimware or error in the wiring connection?

---

Either the connection or you did not activate ready mode before trying to remote start.

Manual cars you need to activate ready mode before attempting to remote start. The procedure to enable ready mode is in the Quick Guide that came in the EVO-ONE box.

---

??? ???????, ??? ?? ???????? ??? ?????.

? ???????????? ? ?? ????? ?????? ?? ?????? ??? ???????????? ???????? ????? ?? ???????? 3-? ?????????? ?????? ?????????????? ?????????? (?????? ??????? ??????, ??????? ??????, ???????? ??????).

---

??, ?? ???? ?????, ? ?????? ?? ??????????? ????? ??????????. ??? ????????.

?? ???? ?????? ????????.

? ?????? ???????? EVO-ON, ????? ?????????? ????????? ?? ???????????? ??? ???????, ?? ?????? (????????) LED ?????? ??????????? ? LED ?????? ?? ????.

---

??????? ??? ? ????!

? ???? ??? ??????????! ??? EVO-ON - ????? ?????? REMOTE STARTER!

???????!