Questions & Answers

cranks will not start - programming ok

0 votes
I have a FIAT 500L installed Evo-All and all connections installed as per installation guide, using wire to wire method as remote starter was not listed in options. Performed programming and all lights illuminated and extinguished as described in programming procedure. connected to flash link and decryptor transfer of information was successful. installed bypass to vehicle and all functions are working, however when attempting to remote start vehicle will just crank(as if secret key information is not present) confirmed this was the case if i place the key into the ignition and remote start the vehicle all functions are operating correctly.

Notes: when performing lock/unlock and trunk functions the blue light will flash and function will perform. When i attempt remote start function ONLY the yellow light will illuminate on the Evo.

Any and all information greatly appreciated!
closed with the note: speaking through email.
asked Oct 24, 2022 in Fiat by JORDAN MACMURRAY (130 points)
closed Oct 24, 2022 by derek g

1 Answer

0 votes
I see you were already in contact with one of my associates through email.

 

I will close this thread.
answered Oct 24, 2022 by derek g (324,940 points)
...