Questions & Answers

Door Trigger 2013 Murano not functioning

0 votes
Eco all in standalone mode. Everything wired correctly.  With pink/black hooked up all lights stay on with door closed   With wire disconnected remote start works but lights stay on when stopped. If driving vehicle says door open
posté Sept 28, 2019 dans la catégorie Nissan par Mark reite (220 points)

1 Réponse

0 votes
Sounds like the unit is grounding itself through the driver door pin.
répondu Sept 30, 2019 par derek g (346,760 points)
Unit installed with harness. Would the harness be defective then.  Everything seems to work except the pink with black is grounded as soon as the unit is powered up.
commenté Sept 30, 2019 par Mark reite (220 points)
Try running your own ground wire from the black 4 pin connector see if that solves the issue.
commenté Sept 30, 2019 par derek g (346,760 points)
Ran separate ground to 4 pin. Issue still the same.
commenté Sept 30, 2019 par Mark reite (220 points)
try flashing aidfferent version into the module and see if that changes the output, if not, the module has been damaged resulting in that output being grounded all the time.
commenté Sept 30, 2019 par derek g (346,760 points)
Must be defective. Tried different firmware.
commenté Sept 30, 2019 par Mark reite (220 points)
It could also be that options are not set up properly. Example.... Pink/Black is a hand/brake output when stand alone is not enabled.
commenté Oct 2, 2019 par Robert T (301,890 points)
Standalone enabled.
commenté Oct 2, 2019 par Mark reite (220 points)

Questions associées:

...