Questions & Answers

what would cause the yellow lamp on evo all not to flash on initialization

0 votes
2011 chevrolet equinox. Had to replace battery in vehicle after being dead for a few days. while trying to reprogram the unit (evo all) using i cant get the yellow lamp to flash. when i plug the 4 pin connector in it alternates between blue and red only. If i cycle the key a few times the yellow will light up so i know it is operational but wont light when 4 pin is connected. All worked well until battery died. Any ideas if the module needs replacing.
posté Jan 29, 2015 dans la catégorie Chevrolet par eugene grymaloski (130 points)

1 Réponse

0 votes
Must have a very old firmware in there. Lots of update were made in GM since the last few years. Maybe tech support guys can take a look at older guides for programming ?

What's the service number on the unit ?
répondu Jan 30, 2015 par eugene grymaloski (85,210 points)
SERVICE NUMBER 001A02 014433
Try this programming...

https://ifar.ca/download/3304/3304.pdf
...