Questions & Answers

EVO-ONE and THAR-CHR6 on chrysler 300 2014

0 votes
i'm about to install the EVO-ONE and THAR-CHR6 on chrysler 300 2014 , my question is if i connect the RED and BLACK wire of the 6 pin harness from the EVO-ONE to a high power 12v source and ground for Security & Alarm functions, do i still need to connect the 4 pin power harness of the T-harness THAR-CHR6 to the EVO-ONE?
asked Dec 18, 2018 in Chrysler by bao dinh (740 points)

1 Answer

0 votes
guide 74221 should answer that question for you. I can't see why you would want to connect power to the 6 pin connector as it is not required for that vehicle to remote start. The 6 pin connector is only used if high current capabilities are needed.
answered Dec 20, 2018 by Joshua Halsey (630 points)
i want to connect rf kit ,  a siren and shock sensor to the EVO-ONE , but the power of the  t-harness is not strong enough for all that so i have to use the 6 pin connector , so i have to make sure if i already use the 6 pin connector for power , do i still need to plug the 4 pin t-harness power to the evo-one or not , i don't want to do anything wrong , thank you for your answer.
...