2011-2015 ford focus stand alone programming

Question

I installed evo-all. I used manual 2011-2015 ford focus (stand alone). Programming was successful (dcryptor). Pressing on a factory remote control do not responds evo-all. When connected yellow-black wire at minus (2sec.) ignition turns ON and after 10sec. starts the engine. If connect again yellow-black wire at minus, do not shuts down the engine. What to do?

Answer 1

Your module is has diesel mode enabled, this is why it takes 10 seconds to start.

When pressing buttons on factory remtoe does the blue LED on the module flash ?

Comments

No. When pressing, evo-all does not respond.