Without transponder Toyota Yaris 2007

Question

Hello, I need assistance. I don't have a transponder in my Toyota Yaris 2007. I have two black car keys, one of which is a 3-button remote. I selected Function 2-4 and Function 20-2. I installed the "without keyless" 2007 Yaris mod. I disconnected the yellow wires and connected the white one to the start input. During programming, I used the 3-button key, but the red light remains steady. The car isn't working; it only activates the any lights, and the lights flash irregularly. The device is "Evo One 2016" Ftx64-2w.

Answer 1

Hello,

Since your vehicle does not have a transponder, you would do just can bus programming, the programming would be as follows:

1- let go on the blue led

2- plug in all connectors

3- turn key on the blue led should flash rapidly

4- turn key off it should go out

 

At this point you could program the rf kit to the evo-one.

 

Best regards.

Comments

Should the key be in the on position while programming?

And should the 6-pin connector connections remain as they are (normal installation) because some things seem to change when you make it fonction 2/4?

---

In my reply above step 3 says to turn key on, the key should not be on or in the ignition prior to step 3.

Yes leave the 6 pin as shown in the installation guide and select the appropriate option per your installation guide.

---

I tried this way too and after 3 steps, the blue LED continues to glow steadily in the on position.

---

If the blue led does not flash rapidly when ignition is turned on you would want to check the following connections:

1- Ignition

2- Can hi

3- Can lo

 

Best regards.